We are closed for Xmas from 4pm 24th December – Reopening at 9am on the 2nd January 2025

FAST UK DELIVERY
Secure Shopping
Over 100,000 orders shipped
Hassle Free Returns
Trusted by The Trade
Friendly Knowledgable Team
20 Years Established
Click & Collect
CLOSE
HAVE A QUESTION?
CLOSE
SHARE WITH A FRIEND

Enter your name, and your friends name and email address

CLOSE
PERSONALISE YOUR ITEM
CLOSE
BULK ORDER QUOTE
CLOSE
Stock Notification

Koller Electronic Control Box Type 230 8014A

S04-dry-running protection sensor

Extended 1 Year Warranty

In addition to the manufacturers standard warranty (usually 1 year) we also offer the opportunity for you to extend this warranty by a further 1 year for a one off fee. This can be arranged at the point of purchase or within a limited time afterwards.
An extended warranty is an easy way to protect your purchase, against any manufacturing defects causing breakdown. You will benefit from free repairs for the term of the warranty period & If your equipment can't be repaired then we will replace it free of charge.(A delivery surcharge may apply for non UK mainland addresses)
This warranty and the standard manufacturer’s warranty does not cover general wear and tear, abuse or misuse or incorrect installation.
If you would like any further information on our extended warranty scheme please call our Hydrospares team on 01326 371 488 OR email us at info@hydrospares.co.uk

LID: 4763
Koller
3.6kW
4 Function
230V
£255.08 Inc VAT
( £318.85)
ECB-8390
230-8014A-S04
Special Order ItemLead time to be confirmed
Contact for lead time
Fast UK Delivery
Koller Electronic Control Box Type 230 8014A
£255.08
RRP £318.85

Koller Electronic Control Box Type 230 8014A, Variation S04 with 4 functions with dry-running protection sensor.

advantages

It is possible to connect an equipotential bonding (resistance to jamming, EMC insensitive).

The basic adjustments are practicable with a DIP-switch (minimal speed, interval,...).

combi-jet

This program combines the air and water system for the operation of the magic jet.

heating

Switches on automatically when the jet pump is running.

temperature controller

Only when connected to electronic temperature indicator with adjustable function 012 3321C.
Master: The heater switches on when the temperature falls below the set temperature. If the pump has not yet been activated, it will switch on.
Slave: The heater only switches on when the temperature falls below the set temperature and when the pump is already operating.

filling

Automatic filling through a button.
Refill about a button.

zone roller

1-push-operation: one short push of the button changes the sequence or stops the program. A long push of the button puts the program into reference position.

disinfection

Starts through the button disinfection and works then automatically. The bath tub is disinfected after about 35 minutes.

rewash

Function is activated, if water was in the bath tub. Starts about 10 minutes after the tub is empty.
Alternatively it is possible to start / stop this function at empty tub with a button. duration of the rewash: 2 minutes

dry out

Starts automatically, if water was in the bath tub. The dry out starts about 20 minutes after the tub is empty.
Alternatively it is possible to start / stop this function with a button. duration of the dry out: 3 minutes

OFF-Timer

The running time limiter is activated, when the status indicator reads „Pool ready“ and the control panel registers the first pressing of the button. All whirlpool functions may be used as much, as you desire during the operating period. Upon reaching the running time limit, appliances switch off automatically. Should all functions be switched off during this time, the running time limiter will also reset automatically. The appliances may be immediately switched on after the automatic stop.

More Info

Important Information:
Our range of Spa Packs must be installed by a competent individual or tradesman, that is trained within the industry. Spa Packs and other computerised equipment are exempt from our returns policy if they have been opened or installed. If the spa pack is suspected as being faulty, it will need to be returned to us within the warranty period and will then be forwarded to the manufacturer for inspection. If deemed to be faulty, we will replace under warranty. If the board is not at fault or is found to have been damaged due to installation, an additional charge will be required to cover the costs of shipping and return.
 *Please ensure this is the correct Spa Pack as this item is non-refundable - If you are unsure, please contact our friendly customer service team for advise & support

Customer Reviews

Write a review

star
star
star
star
star
Questions & Answers

Submit a question

 
warning
Confirm add to basket
Return to listing
Add to basket
COMPARISON BASKET
COMPARE