Last Few Available
Vacuum Switch Tecmark - VTBS3002-950 To be used on the suction side of the pump to indicate sufficient water flow through the heater
Height: 48mm
Width: 25mm at widest point
Depth: 48mm from front to rear spade
Up to 125vac. 21A (5kW) 3/8 inch MPT screw thread. Common used with in line bath heaters assembled before the water enters the pump wet end.
Commonly used as an interlock device to sense gas, air or water pressure at a specific point. Usually Fitted to the suction side of your pump.
Tecmark Series V4000 Vacuum Switches convert a negative pressure signal to an electrical output. In response to a change in negative pressure, movement of an elastomeric diaphragm opens or closes an electrical circuit based on a predetermined pressure set point. The Series V4000 features cost effective, snap-acting electrical switches and field adjustable set points. Vacuum ranges from -2.5" (-600 Pa) Water Column (W.C.) to -10.75 PSI (-75 kPa) are available. Consult factory for vacuum levels outside listed ranges. Series V4000 switches assure control stability through wide and variable temperature and humidity conditions and assure uninterrupted service under extreme shock and vibration. As with all Tecmark® products, series V4000 switches provide superior performance and 100,000 cycle life under full mechanical, electrical and thermal loads.
Provide on/off control of:
- Electric or gas heaters
- Pumps
- Small air compressors
- Electric strip heaters in VAV systems
- Waste oil heating systems
- Residential boilers
- Other electrical equipment in pneumatic or fluid flow systems
Basic Construction
- Elastomeric diaphragm eliminates the need for an oil barrier
- Field adjustable pressure set points. Factory calibration available upon request
- Built in over pressure protection designed to eliminate stress on other critical operating components
- UL Recognized, Canadian and United States, as an operating, limit or safety control
- Available with CE approved electrical snap switches
Available Features
- Vacuum ranges from -2.5" WC to -10.75 PSI (-600 Pa to -75 kPa)
- SPST or SPDT switching logic
- 1/4" male quick connect for electrical connections
- A variety of mounting pan and pressure fitting materials; stainless steel, injection molded plastic and plated steel
- Wide array of pressure fittings; 1/8" NPT male, 1/4" NPT male, 3/16" barbed, 1/8", 3/16" or ¼" compression, or 1/8" NPT female with ½" conduit male external thread for mounting
- Optional vacuum set point locking mechanism
- Specialty diaphragm materials; Buna-N, EPDM, Hydrin
Ratings and Specifications
- Maximum Operating Pressure and Hydrostatic burst pressure, varies based on model configurations. Consult factory for specific application needs.
- Electrical ratings to 25 amp, 250 VAC.
- Field tested critical components specifically selected to operate reliably in temperature extremes of 32° to 190° F (0°C to 88°C).
- 100,000+ cycle life under full mechanical, electrical and thermal loads.
