Gecko Topside Control Panel - in.k200
In.k200 compact series of entry-level keypads gives complete control to wet fingers! Compact, in.k200 has been designed to be easy to master.
Well Designed
Designed to be easy to master, in.k200 works perfectly in smaller spas equipped with one or 2 pumps. Function light indicators and built-in timers will make user's life easier.
Intuitive
No need for thick manuals with complicated instructions. A few intuitive presses on labelled keys will command the pumps, blower and light.
All-in-One
With its three digits, 7 segment display, 4 keys and 7 light indicators, in.k200 keypad is the complete spa user's solution coming in a discreet and elegant package.
Spa System Settings:
Programming Purge Cycles: To program the purge cycles, you must select the frequency. During a purge cycle, all the pumps and the blower run for one minute.
Programming Filter Cycles: Depending on the configuration of your system, this will perform either purge cycles or filter cycles. To program the filter cycles, you must enter the duration and the frequency parameters.
Water Temperature: The system generates water flow through the heater housing and plumbing to ensure accurate water temperature readings and avoid heater activation in dry conditions. After verifying pump activation and taking a water temperature reading if required, system automatically turns the heater on to reach and maintain water temp. at Set Point. The Heater indicator lights up when the heater is on. It flashes when there is a request for more heat but the heater has not started yet.
Smart Winter Mode: SWM protects your system from the cold by turning the pumps on several times per day to prevent water from freezing in the pipes. The SWM indicator lights up when it is on. After heating the spa water at the desired set point, the heater is turned off, but its associated pump (Pump 1 Low-speed or CP) remains on for a certain amount of time to ensure an adequate cooling of the heating element, which extends its useful life. The heater icon will flash during this operation.
in.k200 works with Gecko's in.xe and Y series of control systems:
