Balboa PCB - 54504 GL2000 MK3 Spa Pack -HSEX2000 HydroSpa
This circuit board is a genuine Balboa replacement for boards labeled 54504 fitted to plastic Balboa GL2000 MK3 HydroSpa spa control packs.
This is a Genuine HSEX2000 board so the dip switches are set for use with HydroSpa controls. This board can also fitted to Balboa spa packs (55048-04)
The GL2000 MK3 PCB's are compatible with the Balboa's High end ML range of topside controls.
The PCB should be fitted with all the dip switch settings the same as the faulty PCB being replaced. For correct installation, the PCB should be fitted by a qualified tradesman or electrician.
Please Note:
These are generic boards. If you are replacing a customised board you may encounter inconsistency with the topside control. Customised board are specified by the hot tub manufacture for specific models. Although the boards may look the same the will be programmed to the hot tub manufactures specifications. Custom boards are usually only available from the hot tub manufacture and, if available are usually quite expensive.
If you do experience inconsistencies after fitting a generic board then replacing the topside control panel as well usually remedies this.
PCBS - Non refundable (unless faulty)
*Please ensure you take care to select the correct PCB for your application, as all PCBs are non-refundable items - If you are unsure, please contact our friendly customer service team and we will do our best to give you the information we have available in order for you to be able to make the correct purchase (we cannot be held liable for any incorrect items purchased)
Note: All equipment must be installed by a competent individual or trades person, in accordance with the relevant electrical & building safety regulations. Installing an incompatible PCB may result in damage to it, and other system components, which is not covered by warranty.
PCB's and other sensitive electrical equipment cannot be returned if the sealed packaging has been opened, tampered with or if the item has been fitted.
If a PCB board is suspected of being faulty, it will need to be returned to us within the warranty period so it can be returned to the manufacturer for inspection & testing. If the item is deemed to be faulty, we will repair or replace it under warranty. If the board is not at fault or is found to have been damaged due to incorrect installation or misuse then the warranty will be void and an additional charge will be made to cover the costs of return shipping.
