LX Wet End Assembly - 3HP - 2" x 2"
LX Wet End Assembly - 3HP - 2" x 2"
Recommended Additions
79mm Centre Suction x 79mm Side Discharge
79mm Centre Suction x 79mm Side Discharge
Product Details
LX - 56F Wet End Assembly LP300 / WP300 - 3.0HP - 2" x 2"
Direct replacement wet end complete with shaft seal for LP300 & WP300 pumps manufactured after 2008.
** 2008 LP & WP pumps and wet ends are manufactured with a shorter suction (approx. 15mm) and discharge port (approx. 30mm). You may find on some hot tubs with very rigid plumbing that the newer versions will not line up with pipework. The wet end faceplate moulding is different and they are also "open" on the rear of the wet end casing as opposed to the pre 08 wet ends which are encased. SEE IMAGES.
If you are replacing a pre '08 version we are finding that the Waterway Executive equivalent tends to fit better.
Technical Specifications
Wet End Information
| Configuration | Center Suction, Side Discharge |
| Impeller Diameter | 116 mm |
| Union Connection Ref | 2 " (Inch) |
| Connection Diameter | 79mm |
| Spare Parts Available | No |
| Thread Type | Male - Buttress |
| Impeller Vane Gap | 12.5 mm |
| Wet End Frame Size | 56F |
| Wet End HP | 3Hp |
Compatible Wet End Thread Size
| Wet End Diagram |  |
Reviews (0)
Reviews (0)
Questions & Answers
Spares
For JA, LP & WP Series
LP & WP Wet Ends - 13mm
LP / WP - Wet End Face Plate
Related Products
For Use with : CMHP, CMCP, FMCP, FMHP
For 2.5 & 3HP Pumps
For Use with Aqua-flo CMHP
Fits Waterway Executive Pump, Gecko Flowmaster Pump, EMG Motors
Centre Suction - 1.0HP - Push Fit Drain Connection
For Use with Spa Flo II Range
For Use with : CMHP, CMCP, FMCP, FMHP
For Use with Aqua-flo XP3
For Use with XP2e - Euro leg 6.1"
For Use with Exectutive 48F Range
For Use with LP200/ WP200 - Post 2008
For 2.5 & 3HP Pumps
For Use with Executive 56F Range
For Use with Tiny Might Pump
For Use with Aqua-flo XP3
For JA/TDA100