HS Pro - Ice Bath Chiller Unit with filter pump - Equipment Pack 
Pre-assembled plumb and play equipment package including the water chiller unit with control panel, a filter pump pre-wired & ready to go. Also includes a suction & return fitting for easy installation.
All mounted on a sturdy 800mm x 600mm plastic pallet for easy transportation and fixings.

Perfect for building your own domestic Ice Bath
No need to add ice - you can set the temperature as low as 3 degrees.
Suitable for ice baths containing approx 400-500L water

Chiller Unit - Control Panel Functions

• Indicator light to show when the chiller is running,
• Temperature Display - The display will show the current water temperature
• Set temperature point - Up and Down
  To change the temperature use the up and down temperature adjustment buttons
• If the chill tub is set to 3 degrees, it will run the chiller until it reaches this temperature.
  Once the temperature then reaches 4 degrees it will turn the chiller on and cool to 3 degrees.
• The default temperature is 3 degrees.

Power Supply 
13 Amp 220v-240v 50/60Hz
The Chiller pack must be plugged directly into an RCD protected circuit on a13-amp socket or box.
Do not use an extension cable

Filter Pump
Includes filter cartridge to help maintain clean water
Change your filter every 3 months and change the water every 8-12 weeks (depending on usage).

32mm Ball Valve is pre-installed for easy maintenance.

Also Includes
1 x Suction Assembly
1x Return Jet Fitting Assembly.
Hole sizes 60mm

• Suction
  1x Suction Cover white SKU: SUC - 0938
• 1x Suction Nut straight - 50mm spigot   SKU: SUC-1768
• A reducing bush 50mm to 32mm SKU: RED-1682
• 1x Gasket SKU: 1812
• 1x Suction Wall Fitting SKU: SUC-1810
  (Recommendation - It is best practice for safety reasons to fit two suctions into the tub, these should be 300mm apart and ideally on different planes. Please see separate listing for additional suctions.)
  
  
• Return
• 1 x Return Hydro Jet - SKU: JET-2148 
• 1x Suction Nut straight - 50mm spigot   SKU: SUC-1768
• A reducing bush 50mm to 32mm SKU: RED-1682
• 1x Gasket SKU: 1812
• 1x Suction Wall Fitting SKU: SUC-1810

Other items you may need....

• The Ice Bath of your choice up to 400/500L volume - (Eg A Barrel, IBC, Inflatable Ice Bath etc)
• If intended for outdoor use you will need to install the chiller unit inside a weather proof housing.
  Note: Adequate ventilation is required.
• A second suction fitting assembly is recommended (to comply with safety recommendations)
• A length of 32mm semi rigid pipe - length depends on installation SKU: 2778
• WDF Glue SKU: 5200P
• Chlorine Tablets, Floating Dispenser and test strips SKU: CHM-9324
• Spare filter cartridge
• Additional 32mm Ball Valves - depending on installation. SKU: VAL-11661