Full 3HP jet power, built for European spas from the ground up.

Gecko's Flo-Master XP2 is the European-specification 3HP dual-speed jet pump in the Aqua-Flo XP2 range. Where lower HP variants use an 80 frame motor, this 3HP model steps up to a 90 frame IEC motor ? built for European 230V/50Hz duty rather than adapted from a North American spec, with the thermal headroom to handle sustained high-speed operation in heavily jetted spas.

• 3HP dual-speed ? high speed for jet boost, low speed for filtration and heating cycles
• 90 frame IEC motor ? 230V/50Hz rated, TUV approved, IPX5 certified
• 800 L/min max flow rate ? 2" centre suction / side discharge, 79mm buttress thread
• Discharge rotatable to 4 positions ? fits most cabinet layouts without replumbing
• Gecko Universeal shaft seal ? field-replaceable, PS-200 compatible
• Dimensions: 414 × 200 × 243mm

Compatibility

Serving as a direct replacement for existing Gecko XP2 jet pumps with 2" union plumbing, this pump is compatible with the full Gecko spa pack and control system range, and is also suitable as a like-for-like replacement for other 2" union spa pumps where cabinet footprint allows.

Installation note

• This pump is supplied without a cable and is intended to be used with your existing pump cable. If a replacement cable is required, a compatible option can be found here: AMP 2-speed pump cable.
• Unions are not included and are available separately: Please see Gecko 2" buttress union pairs for a suitable part.