Waterway Poly Jet Series

Poly Jet Body Assembly - Stacked Jet Body

Waterway jet body to fit poly jet fronts/internals. Supplied with standard length wall fitting 35mm

This Waterway Poly Jet socket has 32 mm sockets for both water and air (venturi suction).

Sockets configured as a tee, like this one, are designed to allow you to daisy chain jets on a relatively fat pipe. This is a simple plumbing configuration for spas with a small number of jets, and makes the entire system easier to disinfect, since there is less pipe and higher flow rates. For this reason, this type of jet is often seen on commercial spas.

Poly Jet Body Assembly

This assembly fits all Waterway Poly Jets. The body attaches to the spa shell, and the jet internal screws into it.

The internal jets are available in two lengths. With the long version of the internal you can install Poly Jets on tanks with a hull thickness up to 31 mm.

The water flow through the sleeve draws air through the venturi effect, which adds bubbles to the water jet and increases the power of the massage. The air inlet of each jet is normally connected to a common manifold, and then to a valve, so that the air/water mixture in the jets can be changed. If you do not want bubbles in the water jets, plug the air inlet with this cap.