Step 1 ? Remove Your Filters
Take out all filters before starting the purge. Rinse them separately or soak them in a filter-cleaning solution.
Removing filters prevents loosened debris from being pulled back into them.

Step 2 ? Open All Jets and Air Valves & Add Sanitiser
Ensure every jet is fully open, including waterfalls, diverters, and air controls.
This allows the cleaner to reach every part of your spa?s plumbing. Raise your sanitiser levels in your water ready to kill anything dislodged during the purge.

Step 3 ? Add Ahh!Some Purge Cleaner
Add the recommended dose of Ahh!Some directly into your spa water.
The concentrated liquid will quickly begin breaking down waste matter and contamination inside the plumbing lines.

Step 4 ? Run Your Pumps for 20?30 Minutes
Allow the Ahh-some to work its magic inside your spa pipework! Do not be alarmed if it presents green or yellow coloured waste in the water, this is normal, especially if the spa or jetted bath has not been cleaned in a while!

Step 5 ? Drain the spa completely
Once the purge cycle is complete, drain all water from your hot tub or swim spa.
This removes the loosened unwanted waste and contamination that has been released.

Step 6 ? Rinse and Wipe the Spa Shell
Rinse the interior surfaces thoroughly. Vacuum jets with a wet and dry vacuum designed to pick up large quantities of liquid if you have one*
Use a soft cloth or sponge to wipe away any remaining residue around the waterline or near jets.

*Domestic vacuum?s are not suitable for this step

Step 7 ? Refill Your Spa and Balance the Water
Refill your spa with fresh water and re-install your clean filters.
Balance your pH, alkalinity, and sanitiser (chlorine or bromine) before use.